ASTM F2038 - 00(2011) Standard Guide for Silicone Elastomers, Gels, and Foams Used in Medical Applications Part I—Formulations and Uncured Materials
4.1 This guide is intended to provide guidance for the specification and selection of silicone materials for medical device applications.
Silicone manufacturers supplying materials to the medical device industry should readily provide information regarding non-proprietary product formulation to their customers either directly, or through the US FDA master file program.
1.1 This guide is intended to educate potential users of silicone elastomers, gels, and foams relative to their formulation and use. It does not provide information relative to silicone powders, fluids, and other silicones. The information provided is offered to guide users in the selection of appropriate materials, after consideration of the chemical, physical, and toxicological properties of individual ingredients or by-products. This guide offers general information about silicone materials typically used for medical applications. Detail on the crosslinking and fabrication of silicone materials is found in Part II of this guide.
1.2 Fabrication and properties of elastomers is covered in the companion document, F604, Part II. This monograph addresses only components of uncured elastomers, gels, and foams.
1.3 Silicone biocompatibility issues can be addressed at several levels, but ultimately the device manufacturer must assess biological suitability relative to intended use.
1.4 Biological and physical properties tend to be more reproducible when materials are manufactured in accordance with accepted quality standards such as ANSI ISO 9001 and current FDA Quality System Regulations/Good Manufacturing Practice Regulations.
1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Users are also advised to refer to Material Safety Data Sheets provided with uncured silicone components.
2. Referenced Documents (purchase separately)
D1566 Terminology Relating to Rubber
F813 Practice for Direct Contact Cell Culture Evaluation of Materials for Medical Devices
AAMITIRS-251 Microbiological Methods for Gamma Irradiation Sterilization of Medical Devices
21CFR211 Current Good Manufacturing Practice for Finished Pharmaceuticals (current revision)
elastomer; foam; gel; HCR; high consistency rubber; liquid silicone rubber; LSR; moisture cure; medical device material; peroxide cure; platinum cure; RTV; Medical materials/applications--specifications; Orthopaedic medical devices--specifications; Silicone surgical implant materials; Surgical implants--specifications; Uncured elastomeric materials
ICS Number Code 11.040.40 (Implants for surgery, prothetics and orthotics)
ASTM International is a member of CrossRef.